Install Transfer Case to 4L60-E Transmission Chevy Tahoe

Install Transfer Case to 4L60-E Transmission Chevy Tahoe

 

Steve

On to the big stuff. From here on out it’s all big bolts and big things. Y pipe baby.

All right. We pulled the trans jack out. It’s being supported by this perfectly measured 2×4 fold it in as if it was across member and there we’re gonna use the transmission jack to bring in Mr. transfer case. All right, that’s good.

Okay. So, we took this part off because I read online that if you drop the transfer case this is the first thing to break and apparently this thing cost a lot of money. So, three big 15 inches and we took it off, cleaned it up, pretty decent and even though the transfer case is not all that pretty it did get somewhat of a cleaning. So, I’m going tp clean this up real good right here and get it really going.

Oh, great.

Robbie

That’s it. All right.

Steve

All right. I wonder if it’ll fit on the car. All right, it fits.

Roy now we’ve got issues, very many issues. All right. Transfer cases get a lot of things to connect to so we’re going to have to figure all that out. So, here we go. You got a connection….

Robbie

Yeah, you need to make this connection….

Steve

A little toofer on the passenger side. You got a toofer in the middle and then coming down all the way on the driver side there’s more and this is where we’re at. We’re basically eye level to where the drive shaft would be, the rear drive shaft. He got your there. But you know what? You get your vent tube for the transmission and that’s really it. So, on the top you got 1, 2 and you want to clip everything all together there there’s clip clips and then I think I just heard her clip one, where did you clip one? More down on the bottom? Show me.

Robbie

Right there.

Steve

All right.

Robbie

And then you have these 2 that go to the…..

Steve

2 that go to the computer and then there’s another one, the vent tube which goes on top somewhere but towards the front above where the computer thing is. All right. We’re done.

All right. Let’s do transfer case. It’s not easy. It’s on, it’s not bolted down yet. But it’s on. So, we need to put that part back on. I don’t know what the hell is but what it does but it needs to go back on. I don’t know what this is, a vent tube I guess. All right, so the vent tube is on right there. See it? Vent tube? All right.

With the 3 bolts, we got that thing back on, trying to figure out what that thing is but it is on and it’s tight. There is a connection there to the computer. I’m calling it a computer thing because I don’t what else to call it and there’s two connections that go to it and then there’s one that goes directly to it. This one had like, I think this had six pins, this had four pins and there was…. 3 of them with two pins: one went up there, one went all the way on the top and one went to the other side and then don’t forget that that tube connects to the top as well. That tube right, there-ish. So, vent tube, that’s the vent tube I guess for the transmission. So, all back in place and tightened up. Don’t forget your gasket obviously and we’re good to go.